What can I do to make the printer "see" the gaps???
ive tried every suggestions and solutions
to bring the barcode printer->
zebra tlp2844
out of dump
Update:thans for your suggestion sir, ive tried every possibilites you've suggested...
but still not able get "out of dump".
Copyright © 2024 QUIZLS.COM - All rights reserved.
Answers & Comments
Verified answer
1) Make sure the label media is properly routed and loaded (refer to your Quick Reference or User's Manual).
2) Make sure you're using proper label media that has gaps/breaks between each label (about 1/8").
3) Make sure the media sensors are not obstructed and are aligned correctly.
4) Make sure the printer and software are correctly configured for the particular label media you're using (type & size).
5) Perform calibration (refer to your User's Manual)..
Best of luck.
UPDATE:
From the Manual:
http://www.bluestarinc.com/techsupport/ZEBRA/Manua...
After loading media, perform the following procedure that measures the length of each label or tag. Make sure the top cover of the printer is closed.
1. Make sure that printer power is off.
2. Press and hold the feed button.
3. Turn printer power on.
4. When the status light blinks, release the feed button.
5. The printer advances the media to measure and verify the length of individual labels or tags. The printer then prints a status summary and remains in diagnostic dump mode.
6. To begin normal operation, tap the feed button. The printer prints "out of DUMP" and advances a label. If the status light remains amber or red or you cannot get this printout, refer to Troubleshooting on page 35.
Refer to the manual link above or below for further help.
Best of luck.
Zebra Tlp 2844 Manual